Materials: Jumbo Storage Cabinets are fabricated of high quality, cold rolled carbon steel, free
of scale or rust and fully pickled. Exposed edges, corners and
surface areas are free of sharp edges and all workmanship is of
the highest quality as measured by the industry. |
|
Finish: All steel components shall be thoroughly cleaned and
phosphatized for rust resistance in a five-stage pre-treatment
process. A high grade of polyester/epoxy powder paint is to be
applied electrostatically with a gloss reading of between 55 and
65. The finish shall have a salt spray rating of 250 hours or more. |
|
Sides: 20 gauge, Flanged at top, bottom and rear, channel formation
in front. |
|
Backs: Flat two pieces with shelf locking strip welded on. |
|
Sill: 18 gauge Channel formation with return flange for door strike.
Flanged at ends. |
|
Doors: 20 gauge, Flanged at top, bottom and rear. Channel formation
at edges. Door strike on left hand door is hemmed for
smooth edge. Reinforced with full length stiffener. |
|
Top: The tops is 20 gauge steel, formed into a “c” channel formation having an offset for
a continuous door strike. The top
is slotted to accept the lock bar from the three-point locking
system. Studs are prewelded to the underside of the KD top
for assembly. Studs are not
used on the welded cabinets. Top
surface is free of holes and
visible attachment hardware. |
|
Locking Mechanism: Three point with 5/8” x 1/8” flat bar and
nylon silencer. |
|
Hinges: Separable two piece hinge. Lower half welded to
sides, upper half to door. Four hinges per door. |
|
Bolts & Nuts: #8 - 32 x 3/8” slotless head bolts with hex nuts.
No exposed bolt heads. |
|
Shelf: Constructed of 24 gauge steel with full welded “BOX”
formation in front and back of shelf and has formed channels
on both ends. All corners are fully lapped and welded at two
points in each corner. The “BOX” formation is welded on a
minimum of 3” centers, the entire length of the box. All shelves
have a profile height of 1-5/16”. Shelf strips are 22 gauge metal. |
|
Handles: Die cast with satin finish. Built-in lock for right hand
door, matching dummy handle on left hand door.
|
